The turning elbow of the kitchen faucet fell off. First of all, you need to see which part it fell from. Generally, there is a buckle at the joint of the turning elbow of the faucet. If it cracks from here, you only need to remove the buckle. , insert the elbow, and then tighten the hexagon screw. If it falls from the connection of the vegetable pool, you should reach under the vegetable pool and screw a hexagon nut at the connector of the vegetable pool. It is responsible for managing the joints on the top of the force kitchen pool, just plug in the elbow and then tighten it. If it is disconnected and unusable because it has been used for a long time, you must buy a new one.kitchen faucet

First of all, you should remove the connector on the sharp bend of the faucet, and clean the connection of the falling elbow, especially some dirt, otherwise it will often fail to connect or leak water, and then use the hexagon socket to screw the fittings first. To the body of the faucet, and finally plug the sharp bend in. Usually leaking faucets at home will be wrapped with that kind of translucent tape, which can effectively stop the flow of water. But this also tells us to choose the specifications when choosing the faucet freely, but my idea is that the faucet is not about how advanced it is, as long as it is convenient and simple to open and close, repair and install.

The elbow of the faucet in the kitchen has fallen off, and the installation is still simple. Many families will encounter a similar situation. In this situation, you first need to buy an accessory. The owner of the hardware store will understand what you want, and then you can use a wrench to install the accessory on the faucet. Finally, You can try the faucet to see if it works. If it is still very bad, it may be that the faucet in your home is old and cannot be used for a long time. At this time, you can just buy a new one.

The turning elbow of the kitchen faucet falls, and the installation is simple. You can remove the connecting piece (a buckle) on the elbow, and use the Allen wrench to screw the fitting to the faucet first, and then plug the elbow. In addition, you can also ask a plumber to help you repair the following. The replacement of faucets is very fast. If your faucet is old, it is better to replace it with a new one. A good faucet is cast as a whole, and the sound is dull when tapped. If the sound is very brittle, it must be made of low-grade stainless steel, which contains more iron elements, and the quality will be one grade worse.

First close the water inlet valve, then hold the bottom of the sink and unscrew the screw, which can usually be unscrewed by hand, and then place the two water inlet pipes on the faucet, first install the short one and then add the long one, After installation, fix it with a screw cap, connect the water inlet pipe to the water inlet, remember to distinguish between hot and cold water, and then wrap it with tape, preferably waterproof tape, tighten it with pliers, and open the water inlet valve. Lie down to see if there is any water leakage or the like. If there is no water leakage, it is fine. If there is water leakage, check whether the screws are tightened and whether the tape is not wrapped properly.