At or near many public sinks, we will see sink soap dispensers. Today we will introduce how to use and install the sink soap dispenser.
What is a Sink Soap Dispenser
The soap dispenser usually includes a liquid outlet faucet fixed on the table top, a soap liquid bottle set under the table top, a liquid discharge mechanism for liquid discharging the soap liquid in the liquid soap bottle, and a pressure button for driving the liquid discharge mechanism. wait.
A typical soap dispenser comes with a sink and is installed near the faucet in the sink. When installing a soap dispenser, you need to check the sink for a soap dispenser hole, otherwise it won't install.
How to Use a Sink Soap Dispenser
Before installing a sink soap dispenser, it should be noted that not all sinks can be fitted with a sink soap dispenser, and only sinks with soap dispenser holes can be installed. Before choosing a sink soap dispenser, you need to match the size of the soap dispenser hole. If the model is wrong, it cannot be installed. Simply install the sink soap dispenser into the soap dispenser hole and turn it clockwise or counterclockwise. were able. After installation, you can check whether the sink soap dispenser works properly.
If you have been idle for a while, some of the soap will congeal in the soap machine. If the amount of soap is small, stir with warm water. This will reduce the soap to a liquid. If the above method is not feasible, use concentrated soap. Remove the liquid, add warm water, and use the soap dispenser a few times until the warm water drains from the soap dispenser, so the entire soap dispenser can be cleaned. Be aware that dust and impurities in the soap can block the liquid outlet. If you notice that the soap in the inner bottle has gone bad, replace the soap. If the soap is too thick, the soap dispenser will not drain. To dilute the soap, add a small amount of water and stir to use.
When using soap for the first time, add water first to expel the air inside, then add soap. When using this product for the first time, there may be some water in the inner bottle and pump head. This is not a quality issue of the product, but a product left over from the factory inspection. At present, with the advancement of technology soap dispenser product technology, high-end soap dispensers on the market have never been clogged.
How to install a sink soap dispenser
1. Install the sink soap dispenser and choose a suitable location. Drill the bottom hole in the concrete wall with a hammer drill and insert the rubber plug. Then screw the metal frame to the wall.
2. When installing the soap dispenser, fix the control box on the metal frame with screws, then put the soap dispenser on the metal frame.
3. In addition, choose a suitable position on the table, punch a round hole with a diameter of 25mm, then install the faucet and fix it with a nut.
4. Next, attach the clip to the soap dispenser tube, then attach the soap dispenser tube to the conduit on the faucet and clamp it.
5. Finally, connect the gear pump motor wire, sensor head cable and power wire to the control box as shown in the picture. When connecting the sensor head cable, fix it with a nut. This completes our sink soap dispenser installation.
